PQ 200 Ambient Air Particulate Sampler

The BGI PQ200 FRM Sampler uses BGI pioneering technology to meet and exceed the requirements for ambient particulate sampling dictated by the U.S Environmental Protection Agency. This includes the design of reliable PM10, PM2.5 and PM1 Inlets, volumetric sample flow rate control, data logging and software for report and data processing

Features:

• Portable sampler for TSP, PM10, PM2.5, PM Coarse, and PM1
• EPA Reference Method for PM10 sampling (Designation No. RFPS-1298-125)
• EPA PM2.5 Reference Method sampler (Designation No. RFPS-0498-116)
• EPA PM Coarse approved sampler
• Only designated reference sampler capable of a 24 hour run on internal built-in 12 volt battery.
• Internal battery provides power during AC power outages meaning you never have sample interruptions.
• Ordered by EPA as the PEP Audit Reference Method
• Only designated Reference Method sampler with solar power option
• Optional solar panel can allow for indefinite operation without charging or connection to an AC power source

Read More

PQ 100 Ambient Air Particulate Sampler

The BGI PQ100 FRM Sampler incorporates BGI pioneering technology to meet the requirements for ambient particulate sampling dictated by the U.S. Environmental Protection Agency. This includes the design of PM10, PM2.5 and PM1 Inlets, volumetric sample flow rate control, data logging and software for report and data processing.

Features:

• miniPM Inlet -Operate the PQ100 at sampling sites as high as 15,000 ft (4,572 meters)
• EPA Federal Reference Method for PM10(Designation No. RFPS-1298-124)
• Optional solar panel can allow for indefinite operation without charging or connection to an AC power source
• PQ100 complete sampling system includes the PQ100 pump, PM10 inlet and downtube, and rigid tripod
• Capable of a 24 hour run on internal built-in 12 volt battery. Internal battery provides power during AC power outages allowing you to avoid sampling interruptions.

Read More

Omni™ FT Ambient Air Sampler

The US Environmental Protection Agency (EPA) encourages state and local air monitoring groups to conduct short-term multi-site pollutant monitoring studies using non-reference method, small portable samplers.

The concept is to "saturate" an area with easily deployed, inexpensive filter samplers, to assess air quality in areas with high concentrations of pollutants or at reclamation sites. BGI has brought this approach to its ultimate development with the addition of a true 5 liter per minute (LPM) inlet.

The additional data acquired using saturation samplers helps air pollution control agencies to evaluate their monitoring networks consistent with requirements in 40 CFR Part 58.

Features

1. miniPM, Multi-cut Inlet, for TSP, PM10, PM2.5, PM1 and PM4

2. Inlet is verified by Health and Safety Executive (HSE) air sampling standards for entry bias ensuring reference method data quality

3. Light weight and field portable (< 5 lbs.)

4. Power: AC, DC and solar

5. Runs for up to 48 hours on internal DC battery

6. Default configuration is PM₁₀

Read More